Weeds compete with crops for soil moisture, along with other resources, which can impact the germination, growth, and seed production of weeds; however, this impact has not been systematically recorded and synthesized across diverse studies. To address this knowledge gap, a global meta-analysis was conducted using 1,196 paired observations from 86 published articles assessing the effect of water stress on weed germination, growth characteristics, and seed production. These studies were conducted and published during 1970 through 2020 across four continents (Asia, Australia, Europe, and North America). Imposed water stress was expressed as solution osmotic potential (ψ_solution), soil water potential (ψ_soil), or soil moisture as percent field capacity. Meta-analysis revealed that water stress inhibits weed germination, growth, and seed production, and the quantitative response intensified with increasing water stress. A ψ_solution greater than –0.8 MPa completely inhibits germination of both grass and broadleaf weeds. A ψ_solution from –0.09 to –0.32 MPa reduces weed germination by 50% compared with the unstressed condition. Moderate soil water stress, equivalent to 30% to 60% field capacity, inhibits growth characteristics (branches or tillers per plant, leaf area, leaves per plant, plant height, root, and shoot biomass) by 33% and weed seed production by 50%. Severe soil water stress, below 30% field capacity, inhibits weed growth by 51% and seed production by 88%. Although water stress inhibits weed growth, it does not entirely suppress the ability to germinate, grow, and produce seeds, resulting in weed seedbank accumulation. This creates management challenges for producers, because weed seeds can survive in the soil for many years, depending on weed species and environmental conditions. Quantitative information compiled in this meta-analysis can be instrumental to model the weeds' multidimensional responses to water stress and designing integrated weed management strategies for reducing the weed seedbank.

Recent innovations in 3D imaging technology have created unprecedented potential for better understanding weed responses to management tactics. Although traditional 2D imaging methods for mapping weed populations can be limited in the field by factors such as shadows and tissue overlap, 3D imaging mitigates these challenges by using depth data to create accurate plant models. Three-dimensional imaging can be used to generate spatiotemporal maps of weed populations in the field and target weeds for site-specific weed management, including automated precision weed control. This technology will also help growers monitor cover crop performance for weed suppression and detect late-season weed escapes for timely control, thereby reducing seedbank persistence and slowing the evolution of herbicide resistance. In addition to its many applications in weed management, 3D imaging offers weed researchers new tools for understanding spatial and temporal heterogeneity in weed responses to integrated weed management tactics, including weed–crop competition and weed community dynamics. This technology will provide simple and low-cost tools for growers and researchers alike to better understand weed responses in diverse agronomic contexts, which will aid in reducing herbicide use, mitigating herbicide-resistance evolution, and improving environmental health.

Site-specific weed management using open-source object detection algorithms could accurately detect weeds in cropping systems. We investigated the use of object detection algorithms to detect Palmer amaranth (Amaranthus palmeri S. Watson) in soybean [Glycine max (L.) Merr.]. The objectives were to (1) develop an annotated image database of A. palmeri and soybean to fine-tune object detection algorithms, (2) compare effectiveness of multiple open-source algorithms in detecting A. palmeri, and (3) evaluate the relationship between A. palmeri growth features and A. palmeri detection ability. Soybean field sites were established in Manhattan, KS, and Gypsum, KS, with natural populations of A. palmeri. A total of 1,108 and 392 images were taken aerially and at ground level, respectively, between May 27 and July 27, 2021. After image annotation, a total of 4,492 images were selected. Annotated images were used to fine-tune open-source faster regional convolutional (Faster R-CNN) and single-shot detector (SSD) algorithms using a Resnet backbone, as well as the “You Only Look Once” (YOLO) series algorithms. Results demonstrated that YOLO v. 5 achieved the highest mean average precision score of 0.77. For both A. palmeri and soybean detections within this algorithm, the highest F1 score was 0.72 when using a confidence threshold of 0.298. A lower confidence threshold of 0.15 increased the likelihood of species detection, but also increased the likelihood of false-positive detections. The trained YOLOv5 data set was used to identify A. palmeri in a data set paired with measured growth features. Linear regression models predicted that as A. palmeri densities increased and as A. palmeri height increased, precision, recall, and F1 scores of algorithms would decrease. We conclude that open-source algorithms such as YOLOv5 show great potential in detecting A. palmeri in soybean-cropping systems.

Comparing fitness of herbicide-resistant and herbicide-susceptible weed biotypes is important for managing herbicide resistance. Previous research suggests there is little to no fitness penalty from amplification of the 5-enolpyruvylshikimate-3-phosphate synthase (EPSPS) gene (a mechanism of glyphosate resistance) in Palmer amaranth (Amaranthus palmeri S. Watson) in controlled studies in the greenhouse or growth chamber. A field study was conducted in North Carolina at three locations naturally infested with A. palmeri to determine vegetative, reproductive, and germination fitness of plants with and without EPSPS amplification grown season-long with cotton (Gossypium hirsutum L.). Seed number was not correlated with EPSPS copy number. However, when plants were binned into two groups, those having an EPSPS copy number ≥2 (relative to reference genes) and those having an EPSPS copy number <2, plant fresh weight and seed number were 1.4 and 1.6 times greater, respectively, for plants with fewer than 2 EPSPS copies. Amaranthus palmeri height and seed germination, and yield of cotton, did not differ when comparing the two binned groups. These data suggest that A. palmeri plants with EPSPS amplification are relatively less fit in the absence of glyphosate, but this reduced fitness does not translate into differences in interference with cotton.

Two species of cleavers, Galium aparine L. and Galium spurium L., are known to inhabit croplands in western Canada. The latter is the more abundant of the two species. An increased abundance of these species over the most recent decades warrants a more comprehensive understanding of their developmental phenology and the cause of this increase. This study aimed to identify the base temperature and emergence characteristics of Galium spp. across different populations from western Canada. A thermal gradient plate experiment was conducted using five G. spurium populations collected from various Saskatchewan (SK) and Alberta (AB) locations. One known G. aparine reference sample was also included. A common garden experiment was conducted using the six Galium spp. populations to determine emergence characteristics. The base germination temperature identified was 2 C for all populations of G. spurium and 4 C for G. aparine. The median germination temperature for G. aparine was 8.34 C, whereas G. spurium had a similar median germination temperature of 6.5 C. Despite similar germination characteristics, the field emergence study revealed differences between populations' initiation of emergence (150 to 250 growing degree days [GDD]) and time to 50% emergence (275 to 470 GDD) in spring. Highly variable emergence among years and populations within the year (200 to 600 GDD in 2013 and 100 to 200 GDD in 2014) were observed during fall, probably due to differences in moisture availability. Cumulative emergence among populations in fall was very low (1% to 9%) compared with spring emergence (2% to 17%). Overall, this study provides evidence for a low base temperature and differences in emergence periodicity among populations, both of which may be significant factors contributing to the seasonal success of this species.

Alfalfa (Medicago sativa L.) hectares in Michigan are declining partly due to reliance on corn (Zea mays L.) silage as a continuous feed source. By interseeding corn and alfalfa, farmers can replace the low alfalfa yield in the establishment year with corn silage while simultaneously establishing alfalfa. A randomized split-block field study was conducted in East Lansing, MI, over 3 yr (2019 to 2021) to determine the critical period of weed control (CPWC) in the interseeded corn and alfalfa system using two corn hybrids with differing leaf architecture (pendulum vs. upright). Whole plots were assigned to corn hybrids interseeded with alfalfa, and subplots were assigned to a surrogate weed, Japanese millet [Echinochloa esculenta (A. Braun) H. Scholz], for the duration of competition treatments. Weed-free and weedy plots were included as controls. At the end of the interseeding year, corn was harvested, while alfalfa was harvested the following year. The CPWC is made up of two components: the critical timing of weed removal (CTWR) and the critical weed-free period (CWFP). Corn hybrid had no impact on the CTWR or CWFP for interseeded corn or alfalfa. Averaged across hybrids, the CTWR was 303 growing degree days (GDD), and CWFP was estimated to be greater than the study duration. The CTWR in the first cutting of alfalfa was estimated to be 369 GDD. The CWFP was estimated to be 394 GDD for a 5% acceptable yield loss for the first alfalfa cutting. Identification of the CPWC in the interseeded system will increase adoption and interest in other interseeded systems that can mitigate potential negative environmental and economic impacts of monoculture agriculture.

High crop densities are valuable to increase weed suppression, but growers might be reluctant to implement this practice due to increased seed cost. Because it is also possible to lower planting densities in areas with no or low weed interference risk, the area allocated to each planting density must be optimized considering seed cost and productivity per plant. In this study, the growth and yield of maize (Zea mays L.), cotton (Gossypium hirsutum L.), and soybean [Glycine max (L.) Merr.] were characterized in response to low planting densities and arrangements. The results were used to develop a bioeconomic model to optimize the area devoted to high- and low-density plantings to increase weed suppression without increasing seed cost. Physiological differences seen in each crop varied with the densities tested; however, maize was the only crop that had differences in yield (per area) between densities. When a model to optimize low and high planting densities was used, maize and cotton showed the most plasticity in yield per planted seed (g seed^–1) and area of low density to compensate for high-density area unit. Maize grown at 75% planting density compared with the high-planting density (200%) increased yield (g seed^–1) by 229%, return by 43%, and profit by 79% while decreasing the low-density area needed to compensate for high-density area. Cotton planted at 25% planting density compared with the 200% planting density increased yield (g seed^–1) by 1,099%, return by 46%, and profit by 62% while decreasing the low-density area needed to compensate for high-density area. In contrast, the high morphological plasticity of soybean did not translate into changes in area optimization, as soybean maintained return, profit, and a 1:1 ratio for area compensation. This optimization model could allow for the use of variable planting at large scales to increase weed suppression while minimizing costs to producers.

Velvetleaf (Abutilon theophrasti Medik.) is a troublesome broadleaf weed that competes with crops for resources such as soil moisture. Water stress can affect the ability of weed species to grow and produce seeds. The objective of this study was to determine the effect of degree of water stress on the growth and fecundity of A. threophrasti using soil moisture sensors under greenhouse conditions. Abutilon threophrasti seeds collected from a corn (Zea mays L.)–soybean [Glycine max (L.) Merr.] field were grown in silty clay loam soil, and plants were maintained at 100%, 75%, 50%, and 25% soil field capacity (FC) corresponding to no, light, moderate, and high water-stress conditions, respectively. Water was added daily to pots based on soil moisture levels detected by a Meter Group 5TM sensor to maintain the desired water-stress level required by treatment. Plants maintained at 100% FC had the maximum number of leaves (28 leaves plant^–1), followed by 21 and 15 leaves plant^–1 at 75% and 50% FC, respectively. Abutilon threophrasti at 100% and 75% FC achieved maximum plant height (108 to 123 cm) compared with 83 cm at 50% FC. Abutilon threophrasti maintained at 75% FC had the greatest growth index (79,907 cm³) followed by 72,197 cm³ at 100% FC and 64,256 cm³ at 50% FC. Seed production was similar at 100%, 75%, and 50% FC (288 to 453 seeds plant^–1) compared with 2 seeds plant^–1 at 25% FC. This is because the majority of plants maintained at 25% FC did not survive more than 77 d after transplanting. Seed germination was 96% to 100% at 100%, 75%, and 50% FC compared with 20% germination at 25% FC. Abutilon threophrasti can survive ≥50% FC continuous water-stress conditions, although with reduced leaf number, plant height, and growth index compared with 75% and 100% FC.

Basal bark treatment of invasive trees is an approach designed to limit damage to non-target vegetation in the vicinity, but non-target injury is still documented. No study of basal bark treatments has examined the release of herbicide residues from roots of treated plants and resulting non-target impacts. Studies were conducted in Alaska interior and coastal boreal forests on basal bark treatments with aminopyralid and triclopyr on active-growth and dormant invasive chokecherry (Prunus padus L.). The study assessed non-target damage and soil herbicide residue using a combination of visual evaluations, bioassays, and soil residue analyses. Non-target damage from herbicide residues were identified in 40% of treatments containing aminopyralid with triclopyr, 60% of treatments containing aminopyralid alone, and 5% of treatments containing only triclopyr. Laboratory studies of aminopyralid treatments to saplings isolated the effects of herbicide exudation from roots, which was found to be significant, and the magnitude was dependent on dose. Herbicide soil residues in field and laboratory experiments were quantified with analytical detection and plant bioassays. Aminopyralid soil residues were identified in 57% of field treatments receiving 8 to 60 ml of herbicide solution (2% ai) and 70% of laboratory treatments receiving 10 µl of herbicide solution (2% to 16% ai). Triclopyr residues were found from one field treatment following dosage with 28 ml of herbicide solution (18.5% ai). Anatomically, plants grown in soils associated with herbicide-treated trees, both in the field and lab, grew less dry mass than non–herbicide treated controls. This study provides the first evidence that root exudation of herbicide following basal bark treatments contributes to non-target damage of adjacent vegetation and to accumulation of soil herbicide residues. This is an important new factor for integrated pest management within basal bark treatment systems and has implications for other herbicide application types such as injections and frill, as well as determining whether root exudation is species or herbicide specific.